Installation Instructions - Utilitech 148007 Manual De Instrucciones

LOCATION
1. Pump (A) should be located within 15 ft. of the water
source, and strainer (C) should be used at the end of
the inlet line.
NOTE: Make sure the inlet hose is NOT coiled or
kinked above or below water level.
The inlet line may be galvanized pipe, plastic pipe, or
reinforced hose. Be sure there are no leaks in the inlet
line, as this may reduce pump efficiency or prevent
priming. Inlet line should be the same diameter as the
discharge line, or larger.
DO NOT use regular garden hose on the inlet line as
it will collapse during pumping.
Standard 3/4 in. garden hose may be used as a
discharge line. Keep the total length as short as
possible for best performance.

INSTALLATION INSTRUCTIONS

1. Attach hose adapters (B) and suction hose
(not provided) to pump. Make sure inlet connection
is air tight.
CAUTION: Use only rigid pipe or reinforced hose
on the pump (A) inlet. Regular garden hose will
collapse when the pump runs.
1
1
A
5
Use only rigid
pipe or
reinforced hose
on the
A
pump inlet.
C
15 Ft.
Maximum Distance
to Water Source
B
Use only rigid pipe
or reinforced hose
on the pump inlet.
In