Installation Instructions - Utilitech PPTP1 Manual De Instrucciones

Estimated Assembly Time: 5 minutes
Materials Required for Assembly (not included): Garden Hose (50 ft. max. length)
Never operate this pump unless it is secured to a solid foundation.
Do not suspend the pump by the discharge hose or power cord.
Keep the pump suction strainer clear.
Do not install pump directly on sand or dirt.

INSTALLATION INSTRUCTIONS

1. Add water (approximately 1-2 Tbsp.) into inlet to
wet the impeller of the pump (A).
2. Attach suction hose (C) by pushing the male
threaded end into the rubber suction strainer (B).
Then, place the strainer in at least 1/2 in. of water at
the lowest point to be pumped.
NOTICE: Make sure the connection is airtight. An air
leak can cause the pump (A) to run dry.
3. Thread the other end of the suction hose (C) to
the suction inlet of the pump (A).
NOTICE: Always ensure the washer in the hose
bib is not damaged. An airtight seal is necessary
for this pump to operate.
Make sure the suction hose (C) and suction
strainer (B) are in the water before plugging in
the pump (A).
2
3
A
5
A
C
B
C