Nice M-BOARD Instrucciones De Seguridad Y Advertencias Para Instalación, Uso Y Garantía página 73

4. Operate the Central, with the Remote Control previously registered
and observe the movement of the gate.
5. The switch will start a learning cycle by performing 3 or 4 drives
automatically (depending on the initial position of the drive nut).
6. During learning we advise not to press the remote control, othe-
rwise the control panel will start the learning cycle again (except in
emergencies).
7. Make sure that the stops are well adjusted, because if the engine
wires are incorrectly connected, when the stop is found, the control
unit will automatically adjust to the correct direction.
8. After activation of the remote control, the control panel will learn
the route, then the control panel will automatically learn the torque
required to move the gate by performing automatic opening and clo-
sing cycles.
9. At the end of the learning, the gate should be in the fully closed po-
sition, otherwise reverse the direction of the limit switches by turning
the PROG switch to the position according to the table below and
pressing LEARN one time.
PROG SWITCH POSITION
1 time
REVERSE DIRECTION
4 times
-
ENGINE DIRECTION
LED BLINKS
2 times
-
5 times
REVERSED
ENGLISH
PROGRAMMING
3 times
-
-
-
73