Tabla de contenido
PH10 PLUS installation and user's guide
http://www.renishaw.com
No probe signal
Possible cause
Probe incorrectly attached
Cable / connections faulty
Probe failure
Probe output disabled by CMM
Poor measurement performance
Possible cause
Loose head mounting
Probe incorrectly attached
Force applied to head during lock up
Incorrect lock up position
Position not qualified
NOTE: Before seeking technical assistance please make a note of the following information:
Your CMM manufacturer and model
The probe head model
The probe head serial number
The head controller serial number
The head controller version number
The LED sequence on the PHC10-3
The stylus configuration fitted
If you experience problems which you are not able to identify or solve satifactorily, please contact your Renishaw representative for further
advice.
Solution
Remove probe and reattach
Check condition of cabling from head to controller
Contact your Renishaw representative
Check probe output
Solution
Ensure all mounting screws are tight and that mounting to the CMM is secure
Remove probe and reattach
Lock and unlock the head
Reposition head correctly
Check qualification information
Issued 01 2013
Page 33 of 48
Tabla de contenido
