SICK LCU-P Manual De Instrucciones página 362

Chapter 11
Operating data
Ambient operating temperature
Storage temperature
Relative humidity (non condensing)
Vibration strength
Shock resistance
Dimensions (W x H x D)
362
Technical data
1
) Maximum voltage limits must not be exceeded, minimum levels must
be achieved.
2
) Applies for short to 0 V, but not short to U
present for short to 0 V.
3
) In case of fault (open circuit in 0 V cable), the output behaves like a
resistor > 13 k
state as LOW. The safe PLC as per IEC 1131-2 recognize this state.
4
) At low switching rates the max. permissible load inductance is higher.
5
) The outputs are tested cyclically in the active state (short-term LOW
switch). When selecting the downstream controllers, it should be
ensured that the test impulses at the parameters listed above do not
result in shutdown.
6 ) The resistance of each individual conductor core to the downstream
controller must be limited to this value so that a cross short between
the outputs is reliably detected. 70 m copper cable of 0.5 mm
resistance approx. 2.5
Equipment of Machines, Part 1: General Requirements must be
complied with.).
7
) Depending on configuration (here for: S10 test contact NC).
8 008 364/NB 86/25-04-00 © SICK AG • Safety Systems • Germany • All rights reserved
min.
0 °C
– 25 °C
15 %
5 g, 10 ... 55 Hz as per IEC 68-2-6
10 g, 16 ms as per IEC 68-2-29
See dimensions drawings
to U . The downstream controller must recognize this
V
. (Furthermore the EN 60 204 Electrical
Operating instructions
typ. max.
+ 50 °C
+ 70 °C
95 %
; overcurrent protection
V
2
LCU-P
has