Talk Function; Nightlight; Paging The Parent Unit - Philips Avent SCD499/00 Manual De Instrucciones

EngliSh
10
 Briefly press the volume + and – buttons on the parent unit until the desired loudspeaker
volume for the parent unit has been reached (Fig. 17).
The displays give visual feedback on the volume settings of the units:
,
- A : parent unit volume switched off / monitoring baby silently;
- P : minimum volume (parent unit and baby unit);
- }: maximum volume (parent unit and baby unit).
Note: If you press the volume + and – buttons too long, the volume is not adjusted.
Note: You only have to adjust the baby unit volume when you use the talk function (see below).
Note: If the volume is set to a high level, the units consume more power.

talk function

You can use the TALK button on the parent unit to talk to your baby (e.g. to comfort your baby).
1 Press and hold the TALK button and talk clearly into the microphone (Fig. 18).
 Release the TALK button when you have finished talking.
Note: When you press the TALK button, you can no longer hear your baby.
Silent baby monitoring
1 Briefly press the volume down (–) button on the parent unit until the volume is switched off
completely (Fig. 19).
The volume is completely switched off when all sound level lights are out.
As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
,
out (Fig. 0).
When the baby unit picks up a sound, one or more sound level lights on the parent unit
,
come on. The louder the sound, the more lights come on.

nightlight

1 Briefly press the nightlight button Q on the baby unit to switch on the nightlight. (Fig. 1)
Q appears on both displays.
,
 Press the nightlight button Q again briefly to switch off the nightlight.
The nightlight dims gradually before it goes out completely.
,
Q disappears from both displays.
,
Note: If you press the nightlight button Q too long, the nightlight does not come on or go out.
Tip: Switch off the nightlight when you operate the baby unit on batteries. This saves power.

paging the parent unit

If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button
on the baby unit to locate the parent unit.
1 Briefly press the PAGE button on the baby unit (Fig. 22).
H appears on both displays.
,
The parent unit automatically resets to medium volume level and produces a paging alert
,
tone.
 To stop the paging alert tone, press the PAGE button again briefly or press any button on the
parent unit.
Note: If you press the PAGE button too long, the parent unit does not produce the paging alert tone.