Screwdriver For Valve Screw Setting - Thermador PRO HARMONY Serie Instrucciones De Ajuste

Step 3: Setting Valve Screws
®
for the STAR
• Before proceeding with the adjustment, SHUT OFF
THE GAS SUPPLY TO THE APPLIANCE PRIOR
TO DISCONNECTING THE ELECTRICAL POWER.
• If the information in this manual is not followed
exactly, fire or shock may result causing property
damage or personal injury.

Screwdriver for valve screw setting:

The provided flat-head screwdriver is used to reposition the
valve screws for minimum flow settings on the knobs.
Setting valve screws on ranges:
1. SHUT OFF THE GAS SUPPLY TO THE APPLIANCE
AND DISCONNECT THE ELECTRICAL POWER.
2. Remove knob from the valve stem by slowly pulling
knob straight out, away from the control panel.
English 2
Burners
WARNING:
Valve Screw
3. Remove the bezel-mounting screw located to the right
of the valve stem using a T-20 Torx screwdriver.
®
4. For ExtraLow valves, turn the valve stem to the LOW
position for proper access to the valve screws through
clearance holes in the XLO
Valve screw access Valve screw access Valve screw access
hole with valve in OFF hole with valve in OFF hole with valve in OFF
position. position. position.
5. To engage the valve screw, insert the included
screwdriver with 1/8" blade into the hole in the bezel
created by removal of the bezel-mounting screw.
®
potentiometers.
Valve screw access Valve screw access Valve screw access
hole with valve in LOW hole with valve in LOW hole with valve in LOW
position. position. position.