Easy Start-Up - hafele Dialock WT2000 Instrucciones De Montaje Y De Servicio

Easy start-up

The wall terminal is supplied in the so-called „simple mode" for stand-alone
(SA) operation. Only this mode is described in these instructions. Other
operating modes are possible only after consultation with your dealer or
service agent.
Ensure that the user keys are not misused by unauthorised persons.
Keep the programming and deletion keys in a safe place, as these
are used to assigning user keys.
At first start-up, the programming and deletion keys must be assigned as
follows.
This step is possible only directly after the supply voltage has been
switched on or after a total reset at the control unit.
The first start-up must be carried out quickly and without interruption.
1. Keep the green programming key and the red deletion key ready.
2. If power is already being supplied to the control unit, switch the power
off.
3. Switch on the power supply. The green LED flashes for a few seconds.
If no green programming key is presented within 5 seconds, and he
red LED flashes, the sequence must be aborted.
In this case no other key must be presented, and power must be
turned off. Step 2 and 3 must be executed again.
4. Hold the green programming key in front of the reader unit while the
green LED is flashing.
The green LED lights continously after successful assignment. Remove
the green key.
The red LED is flashing.
28 Wall terminal Dialock - status: 12.2006 - 732.29.125
125_WL_Buch.indb 28
Mounting and Operating Instructions
05.12.2006 17:11:01