Chicago Pneumatic RX 2 Instrucciones De Operación Y Seguridad página 16

Safety and operating instructions
1. Drive out the spring pin by using a break pin
punch and a hammer. Press the retainer pin out
from the hole at the back upwards until you can
remove it through the hole on the front side.
NOTICE Dismount the insertion tool with a
lifting strap to reduce the risk of crushed body
parts. Some insertion tools are heavy, therefore
lift out the insertion tool in a safe way.
2. Check that the spring pin is not worn out or
damaged. Change if necessary.
Mounting the insertion tool
16
1. Clean and lubricate the bushing plentifully. This
is especially important when mounting a new
insertion tool.
2. Mount the insertion tool.
3. Rotate the insertion tool to spread the grease.
4. Mount the retainer pin, and make sure it remains
in position so it not falls through the boring at
the back.
5. Drive in the spring pin by using a break pin
punch and a hammer, until it is flushed with the
percussion unit.
9800 1050 90 | Original instructions
RX 2, 3, 4, 6, 8