Transport; Storage; Maintenance And Care; Troubleshooting - Würth 0701 138 Serie Manual Del Usuario

Note: The automatic filter dedusting function can
only be switched on/ off when the appliance is
switched on.
To switch off automatic filter cleaning:
–
 Activate the switch. Indicator lamp in the
switch goes off.
To switch on automatic filter cleaning:
–
 Press the switch again. Indicator lamp in the
switch glows green.
Turn off the appliance
 Switch off the appliance at the main switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside and
outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction hose and the mains cable as
shown in the illustration.
 Place the appliance in a dry room and secure
it from unauthorized use.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you trans-
port it.
 Remove the suction pipe with the floor nozzle
from the holder. Hold the appliance at the han-
dle and at the suction pipe to transport it.
 When transporting in vehicles, secure the ap-
pliance according to the guidelines from slip-
ping and tipping over.

Storage

CAUTION
Risk of injury and damage! Note the
weight of the appliance in case of stor-
age.
This appliance must only be stored in interior
rooms.

Maintenance and care

DANGER
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
ATTENTION
Keep the device and the ventilation lou-
vres clean in order to be able to work
well and safely.
If the vacuum cleaner should fail inspite of thor-
–
ough manufacturing and testing procedures,
have the repair performed by a Würth master-
Service centre.
Please indicate the part number taken from the
–
type plate of the vacuum cleaner in case of
questions or spare parts orders.
Exchanging the flat pleated filter
 Open filter door.
 Take out the flat folded filter.
 Remove all soiling in the area of the filter
frame.
 Insert new flat-folded filter.
 Close the filter door, it must lock into place.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.

Troubleshooting

DANGER
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
Suction turbine does not run
 Check the receptacle and the fuse of the pow-
er supply.
 Check the power cable, the power plug, the
electrodes and the receptacle of the device.
 Turn on the appliance.
GB - 4 17