Mains Supply - Würth POWER 50 l Traducción Del Manual De Instrucciones De Servicio Original

Safety equipment
Safety valve
The spring-loaded safety valve [3] triggers if the
permissible maximum pressure is exceeded.
Start-up
Assembly
▸ Fit the wheels as shown (Fig. II).
▸
Fit the compressed air connection [6] as
shown (Fig. III).
Check the condensate drain (Fig. I)
▸
Ensure that the condensate drain [7] is closed.
Check the oil level (Fig. I)
▸
Check the compressor oil level at the oil sight
glass [10].
▸
If necessary, top up oil to the middle of the oil
sight glass (see technical data for the oil grade):
— Screw out the oil sealing screw plug [11].
— If necessary, top up oil to the middle of the oil
sight glass or the marking.
— Screw the oil sealing screw plug back in.
Fill with pneumatic oil (Fig. IV)
▸
Screw on the compressed air oiler [19].
▸
Fill with pneumatic oil until the oil level is between
the two markings.
▸
Screw the compressed air oiler closed again.
Setting up
Incorrect setting up can result in severe
accidents!
Secure the device against rolling
¾
away, toppling over and slipping.
Safety devices and control elements
¾
must be easily accessible at all times.
Do not lay the device on the side. Oil
¾
may escape!
The place of installation of the device must fulfil the
following requirements:
• Dry, protected against frost
• Firm, horizontal and level ground
22
WARNING!
Transport
▸
Do not lay the device on the side. Oil may
escape!
▸
Do not pull the device by the hose or mains
cable. Transport the device by the transport
handle [4].
Operation

Mains supply

Electrical voltage
Only use the device in a dry envi-
¾
ronment.
Only operate the device from a
¾
power source that fulfils the following
requirements: Sockets installed ac-
cording to regulations, earthed and
checked, fuse rating according to the
technical data.
Route the mains cable so that it is not
¾
in the way during work and cannot
be damaged.
Check the device is switched off
¾
before plugging the mains plug into
the socket.
Protect the mains cable against heat,
¾
corrosive liquids and sharp edges.
Use an extension lead that has an
¾
adequate cross-section (see technical
data).
Use an extension cable approved for
¾
outside use. Outdoors, use only ap-
proved and correspondingly labelled
extension cable.
Do not switch the compressor off by
¾
pulling out the mains plug, rather
switch off at the On/Off switch.
Always connect an RCD with a
¾
maximum tripping current of 30 mA
upstream.
DANGER!