Mains Supply - Würth SOLID 24 l OILFREE Traducción Del Manual De Instrucciones De Servicio Original

The place of installation of the device must fulfil the
following requirements:
• Dry, protected against frost
• Firm, horizontal and level ground
Transport
▸
Do not pull the device by the hose or mains
cable. Transport the device by the transport
handle [3].
Operation

Mains supply

Electrical voltage
Only use the device in a dry environ-
¾
ment.
Only operate the device from a
¾
power source that fulfils the follow-
ing requirements: Sockets installed
according to regulations, earthed and
checked, fuse rating according to the
technical data.
Route the mains cable so that it is not
¾
in the way during work and cannot
be damaged.
Check the device is switched off
¾
before plugging the mains plug into
the socket.
Protect the mains cable against heat,
¾
corrosive liquids and sharp edges.
Use an extension lead that has an
¾
adequate cross-section (see technical
data).
Use an extension cable approved for
¾
outside use. Outdoors, use only ap-
proved and correspondingly labelled
extension cable.
Do not switch the compressor off by
¾
pulling out the mains plug, rather
switch off at the On/Off switch.
Always connect an RCD with a
¾
maximum tripping current of 30 mA
upstream.
DANGER!
Producing compressed air
▸
Switch the device on at the On/Off switch [2]
and wait until the maximum tank pressure is
reached.
Once the maximum tank pressure is reached, the
3
compressor switches off.
The tank pressure is indicated at the tank pressure
3
gauge [4].
Attention!
The set control pressure must not be higher that the
maximum operating pressure of the connected air
tools!
▸
Set the working pressure at the pressure regu-
lator [5].
The current control pressure is indicated at the
3
control pressure gauge [6].
▸
Connect the air hose at the compressed air con-
nection [7].
▸
Connect the air tool.
You can now work with the air tool.
3
▸
Switching off the device and pull out the mains
plug if the work is completed or is to be inter-
rupted.
▸
Drain the pressure tank condensation daily at the
condensate drain [12].
21