Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000095-001.book Page 23 Monday, December 3, 2012 2:11 PM
Maintenance and Cleaning
Before any work on the machine itself,
pull the mains plug.
For safe and proper working, always
keep the machine and ventilation slots
clean.
Replacing the Belts
Loosen the screws 36 and remove the covers of the
drive.
Replace torn or worn belts. Fit the inner belt first, so that
the rear pulley at the machine's tilting arm has the belt
mounted. Now fit the outer belt, observing that this belt
and the pulleys engage in each other.
Slowly rotate the axle using the Allen key, while at the
same time sliding on the drive cover towards the tilting
arm. The centring pins must carefully engage.
Replacing the Brushes
Replace the brushes when they have a minimum length
of 5 mm.
Remove the plugs 37 for this, and replace the brushes
with original Würth brushes.
After replacing the brushes, run the machine several
minutes at no-load.
When changing the brushes, also check the condition
of the slip ring. If the slip ring shows any burn or chip
marks, have the machine checked by a Würth cus-
tomer service agent.
Motor Brake
The machine is equipped with a mechanical centrifugal
brake. It ensures that the saw blade comes to a com-
plete stop in less than ten seconds.
When the duration until the saw blade comes to a com-
plete stop is too long owing to worn brake linings, take
your machine to a Würth customer service agent.
Replacing the Batteries of the Laser
Guidance
Unscrew the screws 38 and remove the lid of the bat-
tery compartment.
Remove the exhausted batteries and replace them with
new ones.
Installation is carried out in reverse order.
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
viewed in the Internet under
“"http://www.wuerth.com/partsmanager”"
or be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee in
accordance with the legal/country-specific regulations
from the date of purchase (verified by invoice or deliv-
ery document). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your Würth
sales representative or a customer service agent for
Würth compressed-air and power tools.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national right, power tools
that are no longer usable must be col-
lected separately and disposed of in an environmen-
tally correct manner.
Noise/Vibration Information
Measured sound values determined according to
EN 61029.
Typically the A-weighted noise levels of the product
are: Sound pressure level 96 dB(A); Sound power
level 107 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 61029: Vibrational
2
emission value a
=3 m/s
, uncertainty K=1.5 m/s
h
2
.
23
Tabla de contenido
