Outside Mount - Levolor Roman Shades Instalación

INSTALLATION
OUTSIDE MOUNT (OM)
Bracket
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: Before marking bracket locations, ensure that your bracket placement
will not interfere with any components inside the headrail.
IMPORTANT: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Center the headrail over the window opening at the desired height.
•
Use a pencil to lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 - 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of ¼" between the bottom of the installation bracket and the
top of the window molding.
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 2 screws per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart, and
mark drill hole locations.
12
Corded Lift Control