Handling; Unpacking / Assembly; Hoisting / Moving; Installation Clearances - Mondolfo Ferro As 933 Uso Y Mantenimiento

To move the packed machine insert the forks of a pallet truck in the channels in the base of the pallet (fig.1).
Before moving the machine refer to the chapter HOISTING AND MOVING
ATTENTION
Keep the packing material intact for possible future transport of the machine.
WARNING
Take the utmost care when unpacking, assembling, and setting up the machine as described in
this heading.
Failure to observe these instructions can lead to damage to the machine and injury to the
operator or other persons.
- Remove the upper part of the packing and make sure that the machine has not suffered damage in transit; identify the
points at which the machine is anchored to the pallet.
- The machine comprises five main sections (fig.1):
1 tower
2 tower guard
3 box with pressure gauge
4 air tank
5 cabinet
- After removing the tower 1, it is advised to place it in a horizontal position to prevent it from falling and getting
damaged.
- Take off the side cover.
- Insert the air hose G fig.2 into hole A behind the tower tilt cylinder.
- Assemble the tower 1, insert pin B into hole C and lock with screw and washer D.
- Insert pin E into hole F and into U-bolt F1 on the tower tilt cylinder and lock with ring M.
- Connect hose G to the intermediate connection linked to the tower-lifting cock H.
- Fit the box with pressure gauge 3 on to the tower 1 and lock with screw and washer S.
- Fit the tower guard 2 and lock with screws and washers L.
- Insert the tank 4 outlet into hose Q. Fix the tank 4 to the machine with nuts and washers R and tighten clamp O on
hose Q (T.I. version only).
To remove the machine from the pallet, sling it as shown in figure 3.
This lifting point must be used whenever you need to change the position of the machine. Do not attempt to move the
machine until it has been disconnected from the electrical and air networks.
WARNING
Choose the place of installation in strict observance of local regulations regarding safety in the
workplace.
IMPORTANT: for correct, safe use of the equipment, users must ensure a lighting level of at least 300 lux in the place
of use.
ATTENTION
If the machine is to be installed outdoors, it must be properly protected from adverse weather by a
roof.
Place the tyre changer in the designated work position observing the minimum clearances shown in figure 4.

Handling

UNPACKING / ASSEMBLY

HOISTING / MOVING

INSTALLATION CLEARANCES

25