Electrical Connection - Jocel JFG5I007247 Manual De Instrucciones

ELECTRICAL CONNECTION

Before you connect the gas cooker, please check that the voltage indicated on the rating plate
to ensure that it corresponds to the mains power supply available. Appliance must be connected
with mains supply outlet. The ground wires are easily recognized by its green and yellow color.
Make sure that the "line" and "neutral" wires are installed into their correct terminals. The
installation must be carried out by an authorized electrician only.
Before connecting to the electric supply, make sure that:
1. The protection fuse and the domestic wiring are suitable to carry the total electric load of the
cooker.
2. The electricity supply network (mains) has an efficient earth connecting according to the
established rules and existing regulations.
3. The cooker wire is long enough to reach the socket from where your cooker is situated.
JOCEL WILL NOT BE RESPONSIBLE FOR ANY ACCIDENT CAUSED BY NON-
OBSERVANCE OF SAFETY INSTRUCTION.
THIS STOVE IS EQUIPPED TO OPERATE ONLY WITH PROPANE AND BUTANE GAS.
JOCEL SHALL NOT BE REPONSABLE FOR ANY ACCIDENTS CAUSED BY
MISCELLANEOUS INSTALLATION OF THE COOKER, MACHINING THE GAS HOSE, OR
ANY MAJOR CHANGING MADE TO THE COOKER.
GAS HOSE CONNECTION
First connect one end of the rubber hose to the gas regulator and tighten it with a hose clamp.
The other end should be pushed tightly into the gas hose connector. Tighten it with a hose
clamp, make sure that both ends are tightened otherwise gas might leak and this could be
dangerous.
Make sure all the control knobs are in the "off" position before connecting the gas supply.
Connect the gas regulator to the LPG tank and your units ready for use.
Whenever connecting the hose to the cooker please ensure:
1. The hose does not exceed a length of 1 meter.
2. The hose must not be very tight or twisted and must not show any sharp bends or kinks. If
there is a leak don't repair but replace it.
3. The hose must not touch the back of the cooker.
INFORMATION: Upon completing the installation, check and make sure that all pipes and
hoses are connected correctly. Always use soapy water to check gas leaking. For safety
reasons we would advise you to inspect and change the rubber hose for the gas
connection yearly.
-41-