Motorola PMLN8305 Manual De Instalación Y Usuario página 16

MN007820A01-AB
Chapter 2 : Installation Procedures
Figure 7: PMLN8309 and PMLN8310 Vehicular Cradle Kit Interconnection Diagram
Vehicle
Chassis
Ignition
Switch
Procedure:
1 If the car is not equipped with an internal power supply connection, route the main power cable
red and black leads through the bulkhead, and into the engine compartment.
NOTE: Use an existing opening or, if necessary, drill a 2 cm (26/32 inch) diameter hole
through the bulkhead.
2 To prevent damage to the power cable, insert a grommet into the hole.
The red and black leads must be inserted one by one into the hole.
3 Cut the black lead to the preferred length and connect it to the chassis of the vehicle.
NOTE: Verify that the fuse is at a distance of 20 cm to 30 cm (7.87 in to 11.81 in) away
from the connection point.
4 On the engine side of the bulkhead, connect the red (A+) lead to the vehicle battery. Perform the
following actions:
a Cut the long red lead to the preferred length, strip the edge, and crimp a terminal lug (not
included) to the lead. Verify that the fuse is at a distance of 20 cm to 30 cm (7.87 in to 11.81
in) away from the connection point.
b Connect the red lead to the positive (+) terminal on the vehicle battery. Cable tie the wire
every 10 cm (4 inches) along its length.
NOTE: Verify that the cables in the engine compartment do not obstruct any of the
vehicle controls or touch hot or movable parts of the engine.
5 For ignition installation, perform the following actions:
a Cut the long blue lead to the desired length, strip the edge and crimp a terminal lug (not
included) to the lead. Verify that the fuse is at a distance of 20 cm to 30 cm (7.87 in to
16
Vehicle
Battery
Red
Black
Bulkhead
Blue
1-AMP Fuse
5-AMP Fuse
Grommet
Power Cable