Motorola PMLN8305 Manual De Instalación Y Usuario página 11

2.1.1
Installing PMLN8305 and PMLN8306
Figure 2: PMLN8305 and PMLN8306 Vehicular Cradle Kit
1
2
3
4
1
2
3
4
Perform the following steps or modify the steps to suit the particular vehicle when installing the
PMLN8305 and PMLN8306 Vehicular Cradle Kit.
Procedure:
1 Open the hinge screw and separate the two halves of the mounting bracket.
2 Use the lower half of the bracket as a template. Position it so that the pivot end of the bracket
points toward the bottom of the cradle.
3 Make four holes in the carpet at marked locations by using an awl or similar device.
NOTE: This must be done prior to drilling to avoid damaging the carpet.
4 Mark and drill the holes. Securely mount the bracket half using the four #8x.625 self tapping
screws supplied with the mounting bracket.
5 Secure the cradle to the other half of the bracket by using the four M4x10 mm screws. You can
place the Remote Speaker Microphone (RSM) bracket in between or install it separately.
6 Connect the two parts of the mounting bracket and secure the hinge screw.
Chapter 2 : Installation Procedures
M4x10 mm Screw (x4)
Wipe clean flat surface before using adhesive
pad
Hinge screw
#8x.625" Self Tapping Screw (x4)
MN007820A01-AB
11