Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble
the blades. If screws are overtightened, blades
may crack and break.
Locate 18 blade attachment screws, 18 washers
and 18 hex nuts in hardware pack. Place blade
on TOPSIDE of one of the blade arms that
extend from side of motor housing, aligning
holes in blade with holes in blade arm as
shown in diagram at right. Insert 1 blade
attachment screw from underside of blade
arm. [NOTE: It is recommended to start with
the hole in the middle.] Install 1 washer and
1 hex nut from topside of blade, tightening
with fingers only at this time. Insert the other
2 blade attachment screws and secure blade
with washers and hex nuts. DO NOT tighten
hex nuts completely until all 3 screws have
been installed.
Repeat procedure for remaining blades.
all blades have been installed, be sure all hex
nuts have been tightened securely.
NOTE: Tighten hex nuts twice a year.
9. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 9 for
remote control assembly instructions. If you have
already installed the wall control but do not wish
to use the handheld remote control, please proceed
to Section 10.
If not already separated, gently pull on remote
control cover to separate top and bottom parts.
[Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control as
possible. [Refer to diagram 2.]
As this fan is sold without a light kit, the dimmer
switch (labeled O and D) has been pre-set to the
"OFF" position (O). If you purchase the light kit
and wish to have dimming capability, please
move the switch to the "ON" position (D). [Refer
to diagram 2.]
motor housing
Once
diagram 1
diagram 2
page 7
hex nuts
and washers
blade arm
(pre-attached)
blade attachment
screws
remote control
cover
(top)
(bottom)
wall control
wire
3 4
5
2
1
6
dimmer
switch
wire
blade
wire
Capítulos
Tabla de contenido
