Automated Learning Process; Led Light; Testing Your Fan - Craftmade Windswept WND78 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

10. Automated Learning Process./Activating Code. (cont.)
REMOTE CONTROL

LED LIGHT

FAN OFF
3 4
2
FAN SPEED
1
REVERSE
LIGHT KIT
LED LIGHT:
FAN SPEED, Buttons 1-6:
REVERSE Button:
UP-LIGHT:
LIGHT KIT:
FAN OFF:
ON/OFF Slider Switch:
Select faceplate for remote control and/or wall control and press firmly onto front of remote control and/or wall
control.
IMPORTANT: The Automated Learning Process takes 5 minutes to complete. Please leave the fan "on" for
the duration of the 5-minute programming and DO NOT use the remote control during this
time.

11. Testing Your Fan.

It is recommended that you test fan before finalizing installation.
Locate handheld remote control. Test fan speeds with the
different fan speed buttons (1 - 6) on handheld remote control.
Test the light ON/OFF function with the
the dimmer function by pressing the
down for up to 5 seconds. Test wall control (optional installation)
by locating ON/OFF slider switch on wall control, then set to the
ON position. Test fan speeds and light as was done for handheld
remote control. If the wall/remote control operate(s) the functions
of the fan and light, battery (batteries) has (have) been installed
correctly. If the wall and/or remote control do (does) not operate
the fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use the
button to recirculate air depending on the season. A ceiling
fan will allow you to raise your thermostat setting in summer and
lower your thermostat setting in winter without feeling a
difference in your comfort.
NOTE: If the wall/remote control interferes with other appliances,
change code switches on the wall/remote control to another
code. If you do change the code, turn power off first. After setting
the new code on the wall/remote control, go back to the
instructions for the GT LEARN button in Section 10 (page 8).
IMPORTANT: Remote control (and wall control, if applicable) must
be synchronized with fan in order to function properly.
IMPORTANT
Remote and wall
controls must be
5
SYNC R ONI E with
6
fan in order to
properly function.
UP-LIGHT
FACEPLATE
Lights up when any button is pressed.
Use to control the ceiling fan speed 1-6.
Use to control fan direction.
Use for up-light (if applicable; not applicable for this fan).
Use for light kit (if applicable; light kit sold separately).
Use to turn fan off.
[Wall control only] Use to turn wall control on or off.
button and then test
button and holding it
page 9
WALL CONTROL
LED LIGHT
3 4
2
5
1
6
BATTERY
FAN OFF
FAN SPEED
REVERSE
ON/OFF
SLIDER
SWITCH

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Windswept wnd102Windswept wnd120

Tabla de contenido