Remote Control; Important - Craftmade Windswept WND78 Guia De Instalacion

9. Handheld Remote Control Assembly. (cont.)
Align holes in wall control with posts located
on inside of TOP part of remote control cover
and press together firmly. Place wall control
into BOTTOM part of remote control cover,
aligning posts in top of remote control cover
with post holes in the bottom. [Refer to
diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
10. Automated Learning
Process./Activating Code.

REMOTE CONTROL

(lower portion)
CODE
SWITCHES
DIMMER
SWITCH
12V BATTERY
Install one battery in handheld remote control and one in wall control (if applicable). [Batteries are included.]
IMPORTANT: Remote/wall control will not function unless battery is installed.
CAUTION: Store the handheld remote control away from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if not used for long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK." - When disposing of
household alkaline batteries, it is best to check with your local and state recycling or household hazardous
waste coordinators concerning the specifics of the program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep battery away from children.
CODE SWITCHES & GT LEARN Button: With fan power OFF, set CODE SWITCHES on handheld remote
DIMMER SWITCH:
GT LEARN BUTTON

IMPORTANT:

The code switches in
remote and wall
controls MUST MATCH
for fan to function
properly.
BATTERY
COMPARTMENT
control and/or wall control to desired code setting. Turn fan power
on. Within 30 seconds of powering fan, press and hold GT LEARN
button on remote control and/or wall control for 5 seconds (or until
fan beeps twice) in order to synchronize remotes with fan motor.
Dimming capability is determined by the type of bulbs provided
with the light kit (sold separately).
ON position = D
post hole
remote control
cover, BOTTOM
diagram 3
CODE SWITCHES
DIMMER
SWITCH
OFF position = O
page 8
hole
3 4
5
2
1
6
remote control
wall
cover, TOP
control
WALL CONTROL
(lower portion)
BATTERY
COMPARTMENT
12V BATTERY
post
GT LEARN
BUTTON