Commissioning; Pre-Programming The Rts Control Point; Checking The Direction Of Rotation; Setting The End Limits And Storing The First Rts Control Point - SOMFY Oximo 40 Manual Del Usuario

6. Commissioning

The Oximo 40 WireFree™ RTS is commissioned using an
RTS control point.
Caution! Inis RT and Inis RTS control points are not compa-
tible with the Oximo 40 DC RTS motor.
Caution! If the installation consists of several motors,
only one motor should be activated at a time! (Refer to
the Oximo WireFree™ Battery guide to activate or deac-
tivate a motor using the PROG button located on the
battery).
6.1 Pre-programming the RTS control
point
Caution! Before commissioning the Oximo 40 WireFree™
RTS, have the battery charged fully by a professional
using the Somfy compatible external battery charger (see
Oximo WireFree™ Battery guide).
1) Follow the steps described in the section entitled
"Installing" to connect the motor to the power supply
(battery and solar panel).
2) Simultaneously press the Up/Down buttons on the RTS
control point:
The roller shutter makes an up and down move-
ment, the control point has been pre-programmed
in the motor.

6.2 Checking the direction of rotation

1) Press the up button on the RTS control point:
a) If the roller shutter is raised, the direction of rotation
is correct:
Move onto the section entitled "Setting the end
limits".
b) If the roller shutter is lowered, the direction of rotation
is incorrect:
2) Press the RTS control point STOP/my button
until the roller shutter makes an up and down
movement: the direction of rotation has been
reversed.
3) Press the RTS control point Up button to check
the direction of rotation.
6.3 Setting the end limits and storing the first
RTS control point
Setting the end limits depends on the type of connections
and bolts used as well as whether or not there are stops on
the end slat.
6.3.1 With locking straps and stops on the end slat
If the roller shutter is fitted with locking straps (I) and stops
on the end slat (J), the end limits are automatically set after
the following procedure has been carried out:
1) Press the Up and Down buttons until the roller shutter
moves up and down.
2) Press the STOP/my button until the roller shutter moves
up and down.
3) Press the RTS control point PROG button to program the
first control point:
The roller shutter moves up and down briefly.
The end limit positions have been programmed.
Copyright © 2009 Somfy SAS. All rights reserved.
Oximo 40 WireFree™ RTS
1 2
Connect the motor
(section:
Installation).
1
a
the end limits
b
onto the next step
2 3
I J
1 2
3
PROG.
Setting
Move
33