Installation; Wiring; Commissioning - SOMFY Irismo Wirefree Manual Del Usuario

Safety warning!
For the illustration, see page 111.

2. INSTALLATION

Instructions which must be followed by the drive and home automation professional installing

the Irismo Wirefree motor.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
2.1. INSTALLATION
2.1.1. Installation of the rail (Fig 1)
1) Mark the position of the brackets.
2) Drill the ceiling or the wall at the right places.
3) Attach the brackets.
4) Attach the rail on the brackets.
2.1.2. Installation of the motor (Fig 2)
1) Unlock the motor
2) Insert the motor shaft into the drive pulley hole.
3) Lock the motor.

2.2. WIRING

2.2.1. Connection of the battery pack to the motor (Fig 3)
1) Connect the battery pack in the bottom of motor
2) Twist battery pack till hear a clicks to lock. If battery pack is not weak, motor will emit one "beep" and
LED will green blink for several seconds, then motor is ready to work.
If battery pack is weak, motor will emit one "beep" and LED will red blink for several seconds, charge it
refer 2.2.2
2.2.2. Charge of the battery pack (Fig 4)

Use only the Somfy power charger with this motor.
The Motor can't be use when in charging.
1) Connect the power charger to the bottom of battery pack, or to the top of battery pack (if the battery
pack is not connected to the motor).
2) After connecting the power charger to the battery pack, the LED of the power charger will be red. This
is the charging mode,
3) When the LED turns green, the charge cycle is complete.
Disconnect the power charger, and save it for later use.

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS remote control (Fig 5)
1) Connect battery pack to the motor, refer to 2.2.1.
2) Press the Open and Close buttons on the RTS remote control at the same time: The motorised product moves up and
down, and the RTS remote control is pre-programmed in the motor.
2.3.2. Setting the end limits
At the first command Open or Close, the motorised product make a first run to record the hard stop position.
If need to adjust end limits, refer 2.4.2
Copyright © 2016 Somfy SAS. All rights reserved.

Caution!
EN
Information
5