Quick Commissioning; Memorising The Remote Controls; Setting The Motor Torque - SOMFY Elixo 500 230 V Manual De Instalación

Check the motor wiring
Wire
motor connection Black
Brown
End limit connection Red
Brown
Black
A
switch on the power to the installation before commissioning.

QuiCk CommissioNiNG

memorising the remote controls

to memorise a remote control:
[1] Press the PROG button on the control unit for
2 seconds. The red indicator light will come on.
[2] Press a channel on the remote control to which
the motorisation will be linked within 2 minutes.
The red indicator light flashes, the remote control
has been memorised.
If this procedure is carried out using a channel which
has already been memorised, this channel will be
cleared.
to add other remote controls: repeat the above
procedure.
to add a telis type remote control:
[1] Press the PROG button on the control unit for
2 seconds. The red indicator light will come on.
[2] Press the PROG button on the back of the Telis.
This must be done within 2 minutes. The red
indicator light flashes, the remote control has
been memorised.
to exit programming mode without programming a
remote control: briefly press the PROG button on the
control unit.

setting the motor torque

The motor torque must be set in accordance with current safety
standards before operating the motorisation.
[1] Turn off the power supply.
[2] Using the spanner provided, lock the motor shaft "A".
[3] Using the torque setting handle, tighten the automatic tightening nut "B" to
increase the torque or loosen it to reduce the torque.
at this staGE iN thE iNstallatioN, thE motorisatioN is oPEratioNal.
Copyright © 2008 Somfy SAS. All rights reserved.
Motorisation to the left (A)
Terminal
3
5
11
12
7
2 s
[1]
2 s
[1]
Motorisation to the right (B)
Terminal
5
3
12
11
7
[2]
[2]
B
A
Elixo 500 230 V
B
.......2 min........
.......2 min........
7