Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
MODELS: SE-1562A, SEM-1562A
Automatic Battery Charger
For 6 and 12-Volt Lead-acid Batteries
IMPORTANT SAFETY
INSTRUCTIONS SAVE
THESE INSTRUCTIONS
INTRODUCTION
Your battery charger has been designed to provide
years of service. This instruction manual contains
information on safety, operation, and maintenance of
your new charger. Make sure that you are familiar with
this information before using the charger.
This battery charger is ideal for recharging batteries in
snowmobiles, ATVs, garden tractors and motorcycles. It
also will warm large batteries found in automobiles and
marine applications.
1. Before you use your battery charger, be sure to read
all instructions written in the manual, on the charger
and carton.
2. Do not expose to rain or snow.
3. The use of an attachment not recommended or sold
by the charger manufacturer may result in a risk of
fire, electric shock, or injury to persons.
4. To reduce risk of damage to electric plug and cord,
pull by plug rather than the cord when disconnecting
charger.
5. An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If an extension cord must be used, make sure:
a) the pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
OWNER'S MANUAL
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, IL 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson Avenue, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485
b) the extension cord is property wired and in good
electrical condition; and
c) the wire size is large enough for AC ampere
rating of charger as specified in the following
chart.
Length of Cord
25 Feet
50 Feet
100 Feet
150 Feet
6. Do not operate the charger with damaged cord or
plug replace them immediately.
7. Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified service person.
8. Do not disassemble charger; take it to a qualified
service person when service or repair is necessary.
Incorrect assembly may result in a risk of electric
shock or fire.
9. To reduce risk of electrical shock, unplug the
charger from outlet before attempting any mainte-
nance or cleaning.
10. WARNING - RISK OF EXPLOSIVE GASES.
WORKING IN THE VICINITY OF A LEAD-ACID
BATTERY IS DANGEROUS. BATTERIES GENER-
ATE EXPLOSIVE GASES DURING NORMAL
BATTERY OPERATION. FOR THIS REASON, IT IS
OF THE UTMOST IMPORTANCE THAT EACH
TIME BEFORE USING YOUR CHARGER; YOU
READ THIS MANUAL AND FOLLOW THE IN-
STRUCTIONS EXACTLY.
To reduce the risk of battery explosion, follow these
instructions and those published by the battery
manufacturer. Review the cautionary markings on
the battery charger and battery.
ELECTRIC CORPORATION
1
Read Rules for
Safe Operation
and Instruction
Carefully
AWG Size of Cord
18
18
16
14
00-99-000254/0503
Tabla de contenido
Manuales relacionados para Schumacher Electric SE-1562A
Resumen de contenidos para Schumacher Electric SE-1562A
- Página 1 OWNER'S MANUAL Read Rules for MODELS: SE-1562A, SEM-1562A Safe Operation Automatic Battery Charger and Instruction For 6 and 12-Volt Lead-acid Batteries Carefully IMPORTANT SAFETY b) the extension cord is property wired and in good electrical condition; and INSTRUCTIONS SAVE c) the wire size is large enough for AC ampere...
-
Página 2: Personal Precautions
11. PERSONAL PRECAUTIONS b) Add distilled water in each cell until battery acid reaches levels specified by the battery manufac- a) Someone should be within range of your voice, turer. This helps purge gas from cells. Do not or close enough to come to your aid, when you overfill. - Página 3 c) Check polarity of battery posts. Positive battery A marine (boat) battery must be removed and post is usually larger diameter than the Negative charged on shore. To charge it on board re- post. quires equipment specially designed for marine use.
-
Página 4: Charger Controls
Once the charger goes into the overload state it will not automatically reset to Schumacher Electric Corporation makes this limited the normal charge state, one of the battery warranty to the original purchaser at retail of this prod- clamps must first be disconnected from the uct. -
Página 5: Introduccion
Largo del cordón Tamaño AWG del cordón Cargador de Batería Por Goteo 25 pies Modelo: SE/SEM-1562A 50 pies Para Baterías Galvánicas de 6 y 12 100 pies 150 pies voltios 6. No use el cargador con cordón o enchufe dañado— INSTRUCCIONES hay que reemplazarlos inmediatamente. -
Página 6: Preparativos Para Cargar
Cuidado de nunca dejar caer una herramienta instale una tomacorriente apropiada. Una conexión de metal sobre la batería. Puede producir incorrecta puede dar por resultado riesgo de choque chispeo o cortocircuito en la batería o en otra eléctrico. pieza eléctrica, que a la vez puede causar ADVERTENCIA - Se debe conectar y desconectar explosión. -
Página 7: Siga Estos Pasos Cuando La Batería
c) Enchufe el cordón de fuerza CA en un Conecte la grapa Negativa (Negra) al chasis del receptáculo CA de 120 voltios. vehículo o al bloque del motor, alejado de la batería. No conecte la grapa al carburador, a d) La luz ámbar indica que la batería se está las líneas de combustible, ni a secciones del cargando, la luz verde indica que la batería está... - Página 8 GARANTIA LIMITADA a tierra (de tres puntas); no se debe usar un adaptador con Schumacher Electric Corporation hace esta garantia el cargador. limitada al comprador original al por menor de este producto. Esta garantia limitada no es transferible.