Stihl HL 75 Manual De Instrucciones página 7

English / USA
Service damaged cutter blades before
using the hedge cutter. Always keep
blades sharp. Keep the handles clean
and dry at all times; it is particularly
important to keep them free of oil and
resin to ensure that you can always
maintain a firm grip and safely control
your machine. Stihl recommends that
you always spray the cutter blades with
STIHL resin solvent before starting work
- with engine stopped! You can obtain
this protective spray from your dealer.
Apply generously.
Fueling
Your STIHL hedge cutter uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" of your owner's
manual).
!
Warning!
Gasoline is an extremely
flammable fuel. If spilled
or ignited by a spark or
other ignition source, it
can cause fire and serious
burn injury or property
damage. Use extreme caution when
handling gasoline or fuel mix.
6
Do not smoke or bring any fire or flame
near the fuel.
Fueling Instructions
Fuel your hedge cutter in well ventilated
areas, outdoors.
!
Warning!
Gasoline vapor pressure may build up
inside the gas tank of a two cycle engine
depending on the fuel used, the weather
conditions, and the venting system of
the tank. In order to reduce the risk of
burns or other personal injury from
escaping gas vapor and fumes, remove
the fuel filler cap on your hedge cutter
carefully so as to allow any pressure
build-up in the tank to release slowly.
Never remove fuel filler cap while engine
is running. Select bare ground for fueling
and move at least 10 feet (3 m) from the
fueling spot before starting the engine.
Wipe off any spilled fuel before starting
your hedge cutter and check for
leakage.
Check for fuel leakage while refueling
and during operation. If fuel leakage is
found, do not start or run the engine until
leak is fixed and spilled fuel has been
wiped away. Take care not to get fuel on
your clothing. If this happens, change
your clothing immediately. Never
attempt to fuel a running or hot engine.
!
Warning!
Unit vibrations can cause
an improperly tightened
fuel cap to loosen or come
off and spill quantities of
fuel.
In order to reduce risk of fuel spillage
and fire, tighten fuel cap by hand with as
much force as possible.
HL 75, HL 75 K