Light Kit Led Driver Replacement - Luminance Brands Kathy Ireland Home VOLTA CF590RBQ00 Manual De Instrucciones

12. Light Kit LED Array Assembly Replacement
12.4
Disengage the Fan Motor Assembly 2-Pin Wire
Connector from the 2-Pin Wire Connector of the Light
Kit Assembly (Figure 43).
12.5
Install new Light Kit Assembly by following the assembly
instructions in Section 5, Steps 5.1 through 5.4.
Restore electricity and verify function of the Light Kit.

13. Light Kit LED Driver Replacement

The Light Kit Driver is located in the motor
assembly.
The entire ceiling fan will have to be unwired and
removed from the ceiling outlet box.
If you feel that you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician to complete this repair.
13.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to remove
the ceiling fan from the mounting bracket.
Tools Needed
One Phillips Head Screwdriver
One Stepladder
FAN MOTOR
ASSEMBLY
2-PIN CONNECTOR
LIGHT KIT ASSEMBLY
2-PIN CONNECTOR
Figure 43
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
23
(Continued)
WARNING
WARNING
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF590