Wayne Dalton 8000 Manual Del Usuario página 8

2
Attaching Fully Adjustable
Flagangle to Vertical Track
NOTE: If you have quick install flagangles, skip
Tools Needed:
this step and complete Step 3.
None
Attaching fully adjustable flagangle to
universal vertical track:
Hand tighten the flagangle to the vertical track
using (2) 1/4" - 20 x 9/16" track bolts (or stud
plate if included) and (2) 1/4" - 20 flange hex nuts.
Repeat for other side.
Secure the flange nuts after flagangle spacing is
complete (Step 15).
Attaching fully adjustable flagangle to quick
install vertical track:
Hand tighten the flagangle to the vertical track
using (1) stud plate and (2) 1/4" - 20 flange hex
nuts. Repeat for other side.
Secure the flange nuts after flagangle spacing is
complete (Step 15).
3
Position the horizontal angle as shown. Place tabs
Tools Needed:
of horizontal angle in the key slot of horizontal track.
Hammer
Using a hammer, tap the horizontal angle towards
the curved end of the track until the hole in track and
angle are aligned. Set tracks aside.
NOTE: For larger doors, a full length horizontal angle
may be spot welded to the horizontal track. If the
horizontal angle is not welded, the horizontal angle
will be installed as shown.
8
Please Do Not Return This Product To The Store. Contact your local Wayne Dalton dealer. To find your local Wayne Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com.
Horizontal Angle
Fully adjustable
flagangle
(2) 1/4"- 20 x 9/16"
Track bolts
(2) 1/4"- 20 Flange
hex nuts
Fully adjustable
flagangle
(2) 1/4"- 20 Flange
hex nuts
Quick install
vertical track
Tabs
Hole
Horizontal track
Horizontal angle
Universal
vertical
track
Stud plate
Horizontal angle
Hole
Key slots
Horizontal
track
Horizontal
track
Horizontal
angle
Tabs
Horizontal
Key slots track