How To Set The Time - Orient 48C Manual De Instrucciones

◆ ABOUT THE HAND-WINDING MECHANISM
1) This is a hand-winding mechanical watch.
The mainspring should be fully wound at the same time each day.
If the mainspring is not wound suf¿ ciently, it may cause the watch to gain/lose
time.
2) To wind the mainspring, ensure that the crown is in its normal position and
slowly turn it to the right (clockwise).
Turning the crown to the left (counterclockwise) will have no effect.
When the watch is in a stopped state, the mainspring can be wound suf-
¿ ciently by rotating the crown approximately 20 times.
3) In order to prevent the mainspring from snapping due to over-winding, the
crown will still rotate even when the mainspring is fully wound. (This is not
a fault).
Avoid winding the watch more than necessary.
4) Since the crown will rotate even when winding is complete, wind the watch
using the scale on the power reserve indicator as a guide.
5) After the mainspring is fully wound, the watch will run continuously for more
than 40 hours.

◆ HOW TO SET THE TIME

1 Pull out the crown when the second hand is at the
12 o'clock position.
The second hand stops on the spot.
3