Risk Of Asphyxiation; Risk Of Injection Or Severe Cutting Injury; Risk Of Electrocution Or Electrical Shock - Mi-T-M HSD Serie Manual Del Usuario

READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF
ASPHYXIATION
RISK OF INJECTION
OR
SEVERE CUTTING INJURY
RISK OF
ELECTROCUTION
OR
ELECTRICAL SHOCK
HSD-SERIES Operator's Manual
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury or death may occur
from inhaling engine/burner
exhaust or dangerous vapors.
The engine exhaust from this
product contains chemicals known
to the State of California to cause
cancer, birth defects, or other
reproductive harm.
Serious injury or death could
occur from high pressure spray
penetrating the skin.
Serious injury or death may occur
from contact with electricity.
PREVENTION
This pressure washer was designed for
outdoor use only. Never operate this
pressure washer in an enclosed area.
Always make certain there is adequate
ventilation (fresh outside air) for breathing
and combustion. This will prevent the
buildup of dangerous carbon monoxide
gases. Beware of poorly ventilated areas,
or areas with exhaust fans which can cause
poor air exchange.
Follow all safety instructions provided with
the materials you are spraying. Use of a
respirator may be required when working
with some materials. Do not use this
pressure washer to dispense hazardous
detergents.
Keep clear of nozzle and spray! Never put
your hand, fingers or body directly over the
spray nozzle.
Never point the high pressure discharge spray
at yourself or anyone else.
Always keep operating area clear of all
persons.
DO NOT allow children to operate this unit.
SEEK EMERGENCY MEDICAL CARE if the
spray appears to have penetrated the skin!
DO NOT TREAT AS A SIMPLE CUT!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence
of failure exists, promptly replace all suspect
hoses and fuel lines to prevent the possibility of
injury from the high pressure spray. If a hose
or fitting is leaking, NEVER PLACE YOUR
HAND DIRECTLY ON THE LEAK.
NEVER operate the gun with the trigger wired
in the open position. To prevent accidental
discharge, the trigger gun should be securely
locked when not in use.
Before removing the spray nozzle or servicing
the unit, ALWAYS shut off the unit and trigger
the gun to release trapped pressure. (Even
after you shut off the unit, there is high
pressure water left in the pump, hose and gun
until you release it by triggering the gun.)
DO NOT direct spray on or into electrical
installations of any kind!
electrical outlets, light bulbs, fuse boxes,
transformers, the unit itself, etc.
DO NOT allow metal components of the
pressure washer to come in contact with live
electrical components.
This includes
5