Right Grip Heater - Suzuki 57100-05881 Instrucciones Para El Montaje

4/15
3. Remove screws from the switch
box. First disconnect throttle
cable No.2, then No.1 with care,
and pull out the right side grip.
NOTE: Removed right side grip
Do not try to wrench off the
throttle cable No.1 and No.2
forcibly by using pliers or other
tools. The throttle cable may
be bent, causing improper
return of the throttle.
4. Apply thinly grease to the han-
dlebar.
5. Apply grease to the end of the
throttle cables and cable pulley.
6. Insert the right side grip heater
into the handlebar. Then, install
the throttle cable No.1 first, then
No.2.
7. Set the stopper peg of the
switch box to the hole in the
handlebar and tighten screws.
NOTE: After tightening screws of
GENUINE SUZUKI ACCESSORIES
will not be reused.
WARNING
the switch box, check to
make sure that the switch
box does not rattle.
Switch box
Throttle cable No.1
FWD
Throttle cable No.2
FWD
Switch box
Throttle cable No.1
Stopper
peg
Hole
Throttle cable No.2
Right side grip
Grease
Grease
Right side
grip heater