Check After Replacement Of Main Chassis Or Modules - Bang & Olufsen BeoVision 1 Guía De Servicio

2.24 Adjustments, English

#17 Check after replacement of main chassis or modules

Disconnect the ESD mat from the main chassis
Mount back cover
Picture
Sound
Other
Check that the surfaces of the TV are clean, if not they should be cleaned
- Remove the alligator clip from the aerial input on the main chassis.
- The back cover can now be mounted. Fasten the screws.
- Place the TV in its original stand and place and connect all the cables.
- See Brief operation guide for further information regarding daily use.
- Check that picture on all sources works correctly. Remember satellite and
videotaperecorder, if these are present.
- Check if teletext works correctly.
- Check geometry of both format 4:3 and format 16:9. Adjust if neccesary.
- Check that sound on all sources works correctly. Remember satellite and
videotaperecorder, if these are present.
- If a videotaperecorder is connected to the TV, check whether the record and
playback functions work correctly.
- If the TV is mounted with a motor stand, this should be calibrated. Enter SETUP,
select SERVICEMODE with STOP, STOP, GO. Press the button combination
within 3 seconds. Select STAND with GO. Press GO to calibrate the BeoVision 1.
When done and CALIBRATION OK is displayed, press DISPLAY to exit. Then
check if the stand works correctly.
- See #15 Removal of the contrast screen and cleaning the BeoVision 1 for more
information.