Built-In Opening Requirements & Dimensions; Opening Dimensions - KitchenAid 36" Instrucciones De Instalación

Built-in opening
requirements &
dimensions
All dimensions ±1/8" (3 mm)
* If solid soffit is not available, see
"Anti-tip requirements" on Page 4.
One of the three methods shown
must be used.
The built-in refrigerator can be
installed:
• recessed in the cabinet opening.
• at the end of cabinets using a side
panel to enclose the refrigerator side.
Select one method and use dimensions
given. Dimensions shown provide 0"
(0 cm) clearance.
Mark stud
locations on
rear wall
80" - 90"
(203-229 cm)
above floor.
83-1/4" (211.5 cm) min.
84-3/4" (215 cm) max.
to bottom of solid soffit.*
If optional side panel is used,
install support board on rear
wall if opening depth is
25" (63.5 cm) or more.
Water line must
provide 15-100 psi
(103-690 kPa) water
pressure. Rough in
water line before
installing
refrigerator.
6" (15.2 cm)
3" (7.6 cm)
23-1/2"
(60 cm) min.
1/2" (12 mm) hole for plumbing
can be located anywhere within
shaded area.
*If a recommended water line location is used, no
additional plumbing needs to be purchased.

Opening dimensions

Model 36" (91 cm)
Width min. 35-1/2" (90 cm)
7"
(18 cm)
Grounded electrical
outlet location
Grounded electrical
outlet is required.
Width
Water line
location can be
through floor
*
or wall.
6"
(15.2 cm)
11"
(28 cm)
6"
(15.2 cm)
(15.2 cm)
Floor: Must support refrigerator,
contents, and door panels.
42" (106 cm)
41-1/2" (105 cm)
77"
(196 cm)
The water hookup
connection may be
located in the base
cabinet on either side
of the refrigerator. The
right hand side is
*
recommended.
Note: The access hole
through the cabinet
must be within 1/2"
(12.7 mm) of rear wall.
6"
48" (122 cm)
47-1/2" (120 cm)
Page 3