Switch Housing Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Mia Guia De Instalacion

10. Switch Housing Assembly.

If you wish to use fan WITHOUT the light kit,
remove 2 screws from switch housing plate
opposite each other and partially loosen the other
2 screws.
Connect male plug from motor housing to female
plug from switch housing, matching up the colors
on the male plug with the colors on the female
plug for correct fit. Be sure that the plugs connect
completely.
Align slotted holes in switch housing with
loosened screws in switch housing plate. Twist
switch housing to lock. Re-insert screws that were
previously removed and secure all 4 screws
with a Phillips screwdriver.
Please proceed to Section 12 for final installation
instructions.
11. Light Kit Assembly (Optional).
If you wish to use your fan WITH the light kit,
punch center cap out of switch housing cap with
a screwdriver. Remove the hex nut and lock
washer from threaded rod at top of light kit fitter.
Gently push wires from light kit fitter (one by
one) through hole in middle of switch housing
and screw switch housing onto threaded
rod--make sure fan pull chain lines up with red dot
at top of light kit fitter so that pull chain does not
rub against bulb during operation. Replace lock
washer and hex nut that were previously
removed. Tighten hex nut over lock washer for a
secure fit.
If you wish to use your fan WITH the light kit,
please proceed to Section 11 on the following page
switch
housing
switch
housing
page 8
male
plug
female
plug
cap
hex nut
lock washer
switch
housing
light
kit
fitter
switch
housing
plate