Tabla de contenido
Idiomas disponibles
Idiomas disponibles
9. Switch Housing Assembly.
Remove 1 screw from switch housing plate
(on underside of motor) and loosen the
other 2 screws.
Connect male plug from motor housing to
female plug from switch housing. Be sure
plugs connect completely.
Align slotted holes at top of switch housing
with loosened screws in switch housing
plate. Twist switch housing to lock. Re-insert
screw that was just removed and securely
tighten all 3 screws with a Phillips
screwdriver.
10. Light Kit Assembly (Optional).
Remove 3 screws from switch housing cap.
If you wish to use fan WITHOUT the light kit,
align holes in switch housing cap with holes in
switch housing. Use screws that were just
removed to attach switch housing cap to switch
housing. Please proceed to Section 11 on page 10 to
complete installation WITHOUT the light kit.
If you wish to use fan WITH the light kit, punch
center cap out of switch housing cap with a
screwdriver.
IMPORTANT: Any light kit purchased for use with
this fan MUST be CETL/ETL (or CUL/UL)
APPROVED for WET LOCATION or OUTDOOR
USE.
Locate BLACK (or BLUE) and WHITE wires in
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove hex nut and lock washer from threaded
rod at top of light kit fitter. Gently feed wires (one
by one) from light kit fitter through center hole in
switch housing cap and then screw switch
housing cap onto threaded rod.
["Light Kit Assembly" continued on next page.]
switch housing
plate
switch housing
center cap
threaded rod
page 9
motor housing
male
plug
female
plug
motor
housing
switch housing
switch housing
cap
switch housing
cap
hex nut
lock washer
light kit fitter
Capítulos
Tabla de contenido
