Blade Assembly; Switch Housing Assembly - Craftmade Colossus COL72 Guia De Instalacion

8. Blade Assembly.

This fan can be used with either 3 or 6 blades.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 18 blade attachment screws and washers
and 18 decorative nuts in hardware packs. Place
blade arm on TOPSIDE of blade, aligning holes in
blade arm with holes in blade as shown. [Be sure to
note label on blade indicating THIS SIDE UP and turn
blade so that label faces up.] With fingers, insert
three blade attachment screws (along with washers)
from the TOPSIDE of blade and 3 decorative nuts
from UNDERSIDE of blade, making sure to
completely insert each screw so that the blade arm
can be attached correctly. Repeat procedure for
remaining blades. Securely tighten screws with a
Phillips screwdriver.
Align blade arm holes with motor screw holes and
attach blade arm with lock washers and blade arm
screws previously removed in Step 5. Before
securing screws permanently, repeat this procedure
with remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.

9. Switch Housing Assembly.

Remove 4 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws.
Align slotted holes in center of switch housing
plate with loosened screws in fitter plate,
allowing molex plugs from motor housing to
come through hole in middle of switch housing
plate. Twist switch housing plate to lock. Re-insert
screw that was removed and secure all 3 screws.
Align holes in switch housing cap with holes in
switch housing plate. Re-insert screws that were
previously removed and use a Phillips screwdriver
to secure all 4 screws.
lock washers
blade arm
screws
motor housing
fitter
plate
page 8
motor housing
blade arm
blade
decorative nuts
molex
plugs
switch housing
plate
switch
housing cap