Switch Housing Assembly; Testing Your Fan - Craftmade Monaghan Guia De Instalacion

9. Switch Housing Assembly.

Remove 3 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside
of motor and partially loosen the other 2 screws.
Align slotted holes in center of switch housing
plate with loosened screws in fitter plate,
allowing male plug from motor housing to
come through hole in middle of switch housing
plate. Twist switch housing plate to lock.
Re-insert screw that was removed and secure all
screws.
Connect male plug from motor housing to
female plug from switch housing. Make sure
plugs connect tightly.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that were
previously removed and use a Phillips
screwdriver to secure all screws.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain. Start at the OFF position (no
blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM-HI. Third pull will set the fan to
MEDIUM-LOW. Fourth pull will the fan to LOW. Fifth
pull will again set the fan to OFF setting. (diagram
1) If fan does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
motor housing
fitter plate
male plug
female plug
switch housing
reverse switch
diagram 1
diagram 2
page 7
switch
housing
plate
pull chain
extension
diagram 3 diagram 4
motor
housing