Switch Housing Plate Assembly - Craftmade Forum Guia De Instalacion

9. Switch Housing Plate Assembly.

Remove 4 screws from outer edge of fitter
plate (save screws for later use).
Remove 1 screw from motor plate on
underside of motor assembly and partially
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws in
motor plate, allowing molex connections from
motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 1.]
Align holes in fitter plate with holes in switch
housing plate. [Refer to diagram 2.]
Re-insert screws that were previously removed
and use a Phillips screwdriver to secure all
screws. [Refer to diagram 3.]
motor
plate
diagram 1
diagram 2
diagram 3
page 9
motor housing
fitter plate
molex
connections
fitter plate
switch
housing
plate
fitter plate
switch
housing
plate
motor
housing
motor
housing