Blade Assembly; Switch Housing Assembly. Pgs - Craftmade Yorktown Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Align blade arm holes
with motor screw holes and attach blade arm
with blade arm screws/lock washers. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
9. Switch Housing Assembly.
Remove 4 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on
underside of motor and partially loosen the
other 2 screws. Align slotted holes in center
of switch housing plate with loosened
screws in fitter plate, allowing male plug
from motor housing to come through hole
in middle of switch housing plate. Twist
switch housing plate to lock. Re-insert screw
that was removed and secure all screws.
NOTE: If you wish to use the fan with a light
kit (sold separately), please proceed to
Section 11; otherwise please continue with
the instrucitons in Section 9 on the
following page.
male plug
switch housing
plate
page 7
motor housing
blade attachment
screws and washers
blade
blade arm
blade arm screws/
lock washers
motor
housing
fitter plate