Switch Housing Assembly - Craftmade Ellington PAT64ABZC5 Guia De Instalacion

9. Switch Housing Assembly.

Remove 3 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside
of motor and partially loosen the other 2
screws. Align slotted holes in center of switch
housing plate with loosened screws in fitter
plate, allowing male plug from motor housing
to come through hole in middle of switch
housing plate. Twist switch housing plate to
lock. Re-insert screw that was removed and
secure all screws. (diagram a)
Connect male plug from motor housing to
female plug from switch housing. Make sure
plugs connect tightly. (diagram b)
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were previously removed and use a Phillips
screwdriver to secure all screws. (diagram b)
male plug
switch
housing
plate
diagram a
switch
housing
plate
switch housing
diagram b
page 8
motor
housing
fitter plate
motor
housing
male plug
female plug