Switch Housing Assembly; Testing Your Fan - Craftmade ELLINGTON SUA56BNK5 Guia De Instalacion

9. Switch Housing Assembly.

Remove 3 screws from outer edge of switch housing
plate (save screws for later use).
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws. Align
slotted holes in center of switch housing plate with
loosened screws in fitter plate, allowing male plug
from motor housing to come through hole in
middle of switch housing plate. Twist switch
housing plate to lock. Re-insert screw that was
removed and secure all screws.
Connect male plug from motor housing to female
plug from switch housing. Make sure plugs connect
tightly.
Align holes in switch housing with holes in switch
housing plate. Re-insert screws that were previously
removed and use a Phillips screwdriver to secure all
screws.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with pull chain. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second
pull will set the fan to MEDIUM. Third pull will set
the fan to LOW. Fourth pull will again set the fan to
the OFF setting. (diagram 1) If fan does not
function, please refer to "Troubleshooting" section
to solve any issues before contacting Customer
Service.
Turn fan completely off before moving the reverse
switch located on the switch housing. Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
fitter
plate
switch housing
motor housing
reverse
switch
diagram 1
diagram 2
page 7
male plug
switch housing plate
female plug
switch housing
pull chain
extension
diagram 3 diagram 4
motor
housing