The unit should be installed as low as possible, BUT NEVER IN THE BILGE OR ENGINE
ROOM AREAS, ENSURE THAT THE SELECTED LOCATION IS SEALED FROM DIRECT
ACCESS TO BILGE AND/OR ENGINE ROOM VAPORS. Installing the unit as low as possible
(such as under a V-berth, dinette seat or bottom of a locker) and ducting the supply air as high as
possible, creates an ideal airflow condition. This type of installation will prevent short or premature
cycling.
The unit should be positioned on a firm, level,
horizontal surface and the condensate drain line
should run downward from the unit to a suitable
drain location. Plan all Connections, which must
be made including ducting, condensate drain, and
seawater in and out, electrical power connections,
location of control, and seawater pump placement,
to assure easy access for routing and servicing.
Aire acondicionado para barcos y yates
Tools required:
Screws drivers
◆
Pliers
◆
Pipe wrench
◆
Wire cutters/crimpers
◆
Drill & 7/8" bit
◆
Jigsaw
◆
Duct tape
◆
Electrical tape
◆
Teflon tape
◆
Bedding compound to seal thru hull
◆
fittings
H a r d w a r e t o s e c u r e u n i t , p u m p ,
◆
strainer, grilles & control panel
5