Line Cut-Off Blade; Adjust The Length Of The Cutting Line; Maintenance; General Information - GreenWorks Pro STC460 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

EN
9.7

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade (11) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9.8
ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade cuts
the excess length.
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
Stop the machine.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
Remove the battery pack.
Cool the motor.
Store the machine in cool and dry place.
Use correct clothing, protective gloves and safety glasses.
10.2

CLEAN THE MACHINE

Clean the machine after use with a moist cloth dipped in
neutral detergent.
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
Keep the trimmer head free of grass, leaves, or excessive
grease.
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
Do not spray water onto the motor and electrical
components.
10.3

REMOVE THE REMAINING LINE

1. Push the tabs (3) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover.
3. Remove the remaining cutting line.
1
2
4. Put the spool cover with spool in the spool housing (4).
10
3
4

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

60t16

Tabla de contenido