Install The Cutting Line; Remove The Trimmer Head - GreenWorks Pro STC460 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Push the tabs until the spool cover clicks into position..
10.4

INSTALL THE CUTTING LINE

Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slot on the spool cap with the line exist hole
on the trimmer head.
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
NOTE
Spool cover
Slot
Line exist
hole
English
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
10.5

REMOVE THE TRIMMER HEAD

1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
11
EN

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

60t16

Tabla de contenido