Adjust The Length Of The Cutting Line; Line Cut-Off Blade; Adjust The Cutting Diameter; Operation Tips - GreenWorks Pro ST60B02 Manual Del Operador

9.3 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade cuts
the excess length.
9.4

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9.5 ADJUST THE CUTTING
DIAMETER
The machine is set at a 11 in. (27.9 cm) cutting diameter.
You can adjust to a 13 in. (33.0 cm) cutting diameter.
Set the cutting diameter to 11 in. (27.9 cm) for greater
runtime and 13 in. (33.0 cm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
NOTE
English
9.6

OPERATION TIPS

Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep a firm hold with the two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
9
WARNING
WARNING
EN