BMW E39 Manual Del Usuario página 15

2. 1 Connections overview of xenon headlight wiring harness
Notes
Refer to general information as well as safety notes in Section 1.
Open out fold-out page!
Item Description
A Xenon headlight wiring harness
Black 8-pin socket housing
A1
White 2-pin pin housing
A2
White 2-pin socket housing
A3
(wire jumper)
Black 1-pin pin housing,
A4
terminal 56 BR
Black, 1-pin socket housing
1
1-pin socket contact,
A5
terminal 56 BR
Connection cable, terminal LWRP
A6
Cable eye dia. 6 mm
A7
terminal 31 ground
Free 1-pin socket contact
2
Black 2-pin socket housing
A8
(Page 2-20)
Cable colour
-
-
White
Brown
Red
Yellow/blue
-
Yellow/blue
Yellow/red
Brown
-
-
Connection location in vehicle
At level sensor in rear right wheelhouse
Connected to branch A3, white 2-pin socket housing,
with red wire jumper from xenon headlight wiring harness
A (after adjustment connected to white 2-pin socket
housing 3 (dummy, green wire) )
Connected to branch A2, white 2-pin pin housing from
xenon headlight wiring harness A (unplugged as part of
adjustment procedure and replaced by white 2-pin
socket housing 3 (dummy, green wire) (see Section 2.4) )
At black 1-pin socket housing 1 provided, with released,
plugged-in socket contact PIN 3 from white 15-pin light
module connector X38
With released, plugged-in socket contact PIN 3 from
white 15-pin light module connector X38 at branch A4 of
xenon headlight wiring harness A
In released plug-in slot PIN 3 of white 15-pin light
module connector X38
With insulation displacement connector at wiring loom of
black 54-pin light module connector X10117 , yellow/red
wire, PIN 34
At ground terminal point X10012 in front area of right-
hand entrance
On vehicles equipped with SA 500 headlight washer
system in series production
Free 1-pin socket contacts are not required.
On vehicles with retrofitted SA 500 headlight washer
system
Free 1-pin socket contacts are crimped onto free wire
ends of disconnected headlight washer system pump
connector X1011
On vehicles equipped with SA 500 headlight washer
system in series production
Branch A8 is not required.
On vehicles with retrofitted SA 500 headlight washer
system
With crimped and connected socket contacts 2, PIN 1,
brown wire and PIN 2, black/brown wire from headlight
washer system pump connector X1011, at branch A9 of
xenon headlight wiring harness A
-
EN/2-5