Fitting The Stand-On Floor Base - NAMCO PANIC PARK Manual Del Operador

4-2 Fitting the Stand-On Floor Base

1. Fit the fixing brackets, finger tight only, to the Anti-Slip Base with the 2off
Kept nuts and flat washers (M6).
2. Fit the Anti-Slip Base to the cabinet with the 4off hex head screws
(M6x15), flat and spring washers. Ensure that the Anti-Slip Base is flat on
the floor before fully tightening the hex head screws (M6x15).
3. Tighten fully the 2off Kept nuts retaining the brackets to the Anti-Slip
Base.
Page 37