Fitting The Header Assy - NAMCO PANIC PARK Manual Del Operador

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10

4-1 Fitting the Header Assy

The header assembly has a forward centre of gravity, so it is important that
at least two people are used to fit or remove the header assembly.
The fitting of the Header Assembly is very high, and it is important that a
means of reaching the height safely, without stretching, is available.
(e.g. steps, step stool etc.)
1.
Place the Header Assembly on to the monitor cabinet and connect the
connector.
2.
Slide the Header Assembly forward so that it engages under the two
retaining brackets.
3.
Fit the 2off Security Screw (M6x16) to retain the header assy in position.
4.
When the machine is in its final position, lower the four level adjusters on
the monitor cabinet, with a spanner so that the machine is level and all
castors are raised from the floor by approx. 5mm. Tighten the lock nuts
with a spanner to ensure that the level adjusters do not move.
Note: If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters to
prevent the machine sliding on the floor when in use.
Page 36
Tabla de contenido
loading

Este manual también es adecuado para:

Final furlong

Tabla de contenido