Light Kit Assembly; Testing Your Fan - Craftmade Beacon BEA48 Guia De Instalacion

9. Light Kit Assembly.

Partially loosen 3 thumbscrews at bottom
of motor housing and raise glass shade to
motor housing. Secure glass shade with
thumbscrews.
NOTE: Be sure thumbscrews make contact
with rubber ring on glass shade but DO
NOT overtighten thumbscrews as glass may
crack or break.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain labeled FAN.
Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test light
with the pull chain labeled LIGHT. If fan and/or
light do (does) not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 3), fan
will not operate.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to the end of the pull chains.
motor
housing
glass shade
light
pull chain
extension
diagram 1
page 8
reverse switch
thumbscrew
rubber ring
fan
pull chain
extension
diagram 2 diagram 3