Fan Assembly - Craftmade Beacon BEA48 Guia De Instalacion

5. Fan Assembly.

5. Fan Assembly.
With the hanging bracket secured to
the outlet box and able to support the
fan, you are now ready to hang your
fan. Loosen canopy set screw and
lower canopy to expose hanging ball
at top of downrod. Remove plastic
from end of safety cable. Grab the fan
firmly with two hands. Slide downrod
through opening in hanging bracket
and let hanging ball rest on hanging
bracket. Turn hanging ball until slot
lines up with hanging bracket tab.
WARNING: Failure to align slot in
hanging ball with tab in hanging
bracket may result in serious injury or
death.
Tip: Seek the help of another person
to hold the stepladder in place and to
lift the fan up to you once you are set
on the ladder.
Find a secure attachment point
(wood ceiling joist highly
recommended) and secure safety
cable. It will be necessary to use a
heavy duty wood screw, washer
and lock washer (not supplied)
with the safety cable loop.
Adjust safety cable length by
loosening screw and nut on the
safety cable vice and pulling on
the cable. Adjust slack in cable to
a hands length and secure vice by
re-tightening screw and nut securely.
[Refer to drawing at right.] The loop
at the end of the safety cable should
just fit over the threads on the wood
screw. Test safety cable by pulling on
loose end of cable with pliers. If the
safety cable slips, the screw and nut on
the vice must be set tighter.
Extra cable slack can be left in ceiling
area.
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be
understood that common sense and caution
are necessary factors in the installation and
operation of this fan.
wood
ceiling
joist
canopy
canopy set
screw
page 5
safety cable loop
hanging bracket tab
hanging ball slot
motor housing
wood screw
and washer
screw
nut
safety cable